Wall-mounted formicarium set

Includes:
1x Wall-mounted ant arena – 30x15x15
1x wall-mounted ant farm – L – 30×30 – glass
1x ant arena frame 30×15
1x ant arena cover 30×15

3x pipe connector crystal clear for 20mm – L
1x pipe connector crystal clear for 20mm – I
1x basin connector 3/4″ to 20mm – crystal clear
1x ant tube – crystal clear 20mm (3x3cm and 1x30cm)
1x spacer for 20 and 32mm clamp holder
2x grid insert acrylic 50mm – clear – fine
1x Formicarium plug for 27mm hole
1x Formicarium cap for 16mm socket
1x formicarium nut 3/4 inch – crystal clear
8x rubber insert for drill holes as protection
8x washers
incl. 8x screws and dowels

Description:
This wall-mounted formicarium set has been developed for wall mounting and is easy to install on wooden and stone walls. Both the arena and the ant farm are fully transparent, allowing a good view of the nest. Either sand and clay or one of our matching cork or Digfix nesting inserts can be used as nesting material for the ants. To connect the ant farm and arena, we have included acrylic tubes cut to size in the set. The screws and plugs for attaching to the wall are also included in the set.

Installation instructions:

Due to the glass panel as a rear wall, the wall underneath should be completely straight.
To fix the 8 “S6” dowels in the wall, you need a drill with a 6mm drill bit (wood, stone or metal depending on the material). 45mm deep holes must be drilled in the wall to countersink the 6x30mm dowels with the 4.5x40mm screws.
Required for assembly:
– spirit level
– Adhesive tape to avoid having to mark on the wall below.
– Phillips screwdriver
– Drill/driver depending on the wall
– 6mm drill bit (wood, stone or metal depending on the surface)
– It is also helpful to make a template for the drill holes from a sheet of paper. Simply place it under the back wall and mark the holes.

Details of the ant farm:
Dimensions (LxH):
Back wall (6mm thick): 400x293mm

Outside (without back panel)
334x28x296mm

Inside
284x20x290 mm

Material:
Float glass

color:
crystal clear

Details of the ant arena:
Dimensions (LxWxH):
Back wall (6mm): 400x150mm

Arena (without back wall): 300x146x150mm

material:
Float glass

Color:
crystal clear

Dimensions (LxWxH):
Back wall (6mm): 400x150mm

Arena (without back panel): 300x146x150mm

material:
Float glass

Color:
crystal clear

Notes on production
The glass is cut to size in accordance with DIN 1249 with a tolerance of +/- 1 mm. Additional break-out protection is essential for extremely small ant species.
As our products are manufactured by hand, minimal deviations may occur despite the utmost care.

Note on the farm
Please note the following when attaching or removing hoses:
If the hose is very difficult to fit onto the connection socket, the socket should be lightly rubbed with a drop of our break-out protection oil or powder. The hose should then be pushed onto the socket using twisting or screwing movements without straining the socket with up and down movements. The same applies when removing the hoses from the farm connection socket. Please do not simply pull it off!